Skip to content

Technology

Heat recovery

The heat from your compressors is too valuable to release into the outside air – use it for heating, hot water and processes.

Waste heat that
pays off

When air is compressed, most of the electrical energy used is converted into heat. Without heat recovery, it is simply lost through the cooling system – even though it can be reused in your own operations with manageable effort.

We check how much heat your system delivers and where you can put it to good use, and we implement the solution professionally – from consulting and installation through to service.

  • Lower heating costs
  • Reduced CO₂ emissions
  • Everything from a single source
Two circulation pumps of a heat recovery system showing flow temperatures of 57 and 56 °C
Up to 94%
of a compressor’s electrical energy is converted into heat – a large part of it can be recovered.

Applications

What you can
use the heat for

Use the heat from your compressors efficiently instead of releasing it unused into the environment. Heat recovery can be eligible for BAFA funding; we will advise you.

  • Space heating

    The warm exhaust air from air-cooled compressors is ducted into production halls, warehouses or workshops. This takes the load off your heating system – especially in the cold season.

  • Hot & domestic water

    Via a heat exchanger, the heat of compression warms water – for showers, sanitary facilities or to support your heating, for example.

  • Process water

    Wherever production needs warm water – for cleaning, preheating or temperature control – the compressor supplies the heat as well.

Atlas Copco energy recovery units in two sizes

Technology

Integrated or
retrofitted

In oil-injected screw compressors, most of the heat is contained in the oil. An energy recovery unit transfers it to your water circuit via a heat exchanger. For Atlas Copco compressors, such units are available factory-integrated or as a retrofit solution.

With air-cooled systems it is often even simpler: the warm cooling air is routed through ducts and dampers to where it is needed – and outdoors in summer if required.

  • Factory-integrated or available as a retrofit
  • For oil-injected screw compressors
  • Heat from the oil circuit can be used
  • Heat exchanger for your water circuit

Heat pumps

Higher temperatures
from waste heat

Not all waste heat is warm enough for your heating circuit. A heat pump raises the recovered heat to the temperature level your heating or process needs – making heat sources usable that would otherwise be too cool.

We supply and install heat pumps and integrate them into your building services together with the heat recovery system. So compressed air, waste heat and heating all come from a single source.

From A to Z

For existing
systems, too

Heat recovery pays off not only with new compressors – many existing systems can be retrofitted. How much you save depends on running hours, output and your heat demand. That is exactly what we determine in advance.

  1. Site survey

    We take a look at your compressors, their running hours and your heat demand on site.

  2. Concept

    Together we decide where the heat delivers the greatest benefit – heating, hot water or process.

  3. Installation

    We install heat exchangers, air ducts and piping and integrate everything into your building services.

  4. Service

    Maintenance, repair and 24/7 emergency service: we remain your point of contact for the entire service life.

More about the efficiency audit
Retrofitted heat recovery station with circulation pumps, insulated piping and three heat exchangers

In practice

A look at a heat recovery system installed by us – click an image to enlarge it.

Druckluftzentrum Dortmund

Giving heat away?
No need.

Get in touch – we will check how you can make good use of the waste heat from your compressors.

+49 231 999 835 00 info@ddz-do.com

24/7 emergency service: 0800 10 11 821 (free of charge within Germany)

Go to the contact form